Use Meguiars M105 Mirror Glaze Ultra-Cut Compound to remove scratches, severe swirls/holograms, acid rain and other defects from your paint finish and leave it with a best-in-class mirror-like gloss. Our exclusive super micro-abrasive technology features ultra-fast cutting ability to remove 1200 grit or finer sanding marks. This professional grade formula is safe and effective on all glossy paint finishes, including clear coats.. Meguiars M105 Mirror Glaze Ultra Cut Compound is formulated with exclusive, super-micro abrasive technology for removing below surface defects like scratches, acid rain, severe swirls and holograms, and up to 1200 grit sanding marks. Using advanced SMAT (Super Microscopic Abrasive Technology) you get an ultra-fast cut that permanently removes defects while leaving a best in class finish with minimal swirls. Meguiars Ultra Cut Compound can be applied by hand, dual action polisher, like Meguiars MT300 DA Polisher, or by Rotary Buffer. This professional auto body compound is safe for a body shop environment and is available in 8 oz, 32 oz and 1 gallon sizes. Follow with Meguiars M205 Mirror Glaze Ultra Finishing Polish to further refine paint and maximize depth of shine before applying a wax or sealant like Meguiars M21 Mirror Glaze Synthetic Sealant 2.0. Distribute a small amount of compound on a Meguiars Soft Foam Applicator Pad Work in a 1-2 square foot area in a circular pattern, making 4-5 overlapping passes per section to ensure that the compound has been properly applied. Without letting the product dry, use a fresh, clean Meguiars Supreme Shine Microfiber Towel to remove the residue. Flip your towel to a clean side for a final wipe. Reapply the compound if you didnt remove the defects with the first application. Apply in sections like this over the vehicle. Attach Meguiars Red Foam DA Cutting Disc to the MT300 DA Polisher. Dispense a small amount of the compound directly onto the pad. Set the MT300 DA Polisher speed between 4,800-5.800 OPMs. Work in a 2 x 2 section applying 2 to 3 overlapping passes with moderate pressure, followed by light pressure for following 2 passes. Do not let product fully dry. Wipe off the residue with a fresh, clean Meguiars Supreme Shine Microfiber Towel. Flip your towel to a clean side for a final wipe. Reapply the compound if you didnt remove the defects with the first application. Apply in sections like this over the vehicle. Work one section at a time. Set rotary buffer to approximately 1000-1500 RPMs. Dispense a small amount of the compound directly onto the paint and begin working in a 2 x 2 area with overlapping passes. Continue working until a light film remains. Wipe off residue before the product dries with a fresh, clean Meguiars Supreme Shine Microfiber Towel. Flip your towel to a clean side for a final wipe. Reapply the compound if you didnt remove the defects with the first application. Apply the in sections like this over the vehicle.
